![]() ![]() IF of course your SDD VCI Gateway Manager (the small Green icon in your Task Bar) Then INSIDE from your SDD you can “Switch” from VCM to your J2534 Device. * After and when you will finish the Driver installation REBOOT your PC! * * For Actia VCI1 i advice to use versions 2.x.y witch are the best for this type of interface – see pdf files. *IF you using PassThru Device (J2534), you need to install now his Driver!* ![]() Proper Firmware and finally you are ready for FULL & Real Operation! ![]() So for to enable in your SDD his Network Option, 1st ENABLE your Internet connectionĪnd go to your SDD System Utilities > Network Options > “Tick” in the small Window >Įnable and then you can start your Update from System Utilites and about theĮCU Calibration Files! (In your SDD screen you must watching the Green Antenna.)Īt your 1st update you must have patience, because it will take A LOT OF TIME!įinally you are now ready to Connect your VCM, IF needs to flash it with the Your Internet Connection and also to Enable in your SDD his Network Option! IF you want to Update your SDD ECU Calibration Files, you need NOW to enable Such as Language, Measurement Units, ect.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |